MIMAKI CF2 Series - Setting the Unit to be Used for Indication [Mode Set] > [Unit]

4-11
SETTING THE UNIT TO BE USED FOR INDICATION [MODE SET] > [UNIT]
The unit to be used when indicating numerics on the LCD is specified.
Set values
mm: Numerics are indicated in millimeters.
inch: Numerics are indicated in inches.
1. Press the key several times until the LCD indicates
page 3 of the LOCAL MENU.
2. Select the [MODE SET].
3. Press the key several times until the LCD indicates
page 5 of the [MODE SET].
4. Select one of the following as a setting for the [UNIT].
mm, inch
5. Enter the input values.
Press the key to enter the input values. If you do not enter the
input data,
press the key.
［LOCAL］ １ ／ ４
TOOL SELECT ――― ＞
CONDITION ――― ＞
TEST CUT ――― ＞
［LOCAL］ ３ ／ ４
INTERFACE ――― ＞
MODE SET ――― ＞
SELF TEST ――― ＞
< MODE SET > １ ／ ６
Z STROKE ＊ ７ ｍｍ ＞
MULTI–PASS ――― ＞
RESERVE
< MODE SET > ５ ／ ６
PEN ASIGN ――― ＞
RESERVE
UNIT ＊ mm ＞
< MODE SET > ５ ／ ６
PEN ASIGN ――― ＞
RESERVE
UNIT inch ＞
［LOCAL］ ３ ／ ４
INTERFACE ――― ＞
MODE SET ――― ＞
SELF TEST ――― ＞