5-3
PRECAUTIONS IN PREPARING DATA WITH REGISTER MARK
There are some limitations on preparing data with register marks.In order to make full use of this function, read the
following instruction carefully and prepare data with register mark.
Size of the square mark
Each side of square mark must be in the range of 5 to 30mm (5mm increments).
Each side of square mark must be in the range of 5 to 30mm (5mm increments).
Refer to [The size of, and the distance between, square marks] ( P. 5-8)for the relationship between the data and
the length of one sided of a square mark.
• The register mark described here is intended to detect the sheet inclination and the lengths
along the X and Y axes. It is not a mark for trimming.
To Next Page
Loading...
