xv
With its most-advanced functions, high-quality finish is promised
■Start/end point correction
In the case of processing heavy-weight works, works can be easily cut out by correcting the start and end posi-
tions for cutting.
■Pressure correction
In the case of cutting heavy-weight works, works can be fully cut with no portion remained uncut by correct-
ing the pressure employed to lower the tool.
■Circle θ correction
When cutting out a circle, the start and points of cutting sometimes fail to align in accordance with thickness
and hardness of the work used. However, an almost regular circle can be cut out by correcting the amount of
such a departure.
■Eccentric correction
The curve cutting accuracy can be improved by shifting the center toward the cutting direction.Moreover, the
cutting direction and the position of the cutter at right angle can be adjusted as desired. This enables accurate
cutting without depending on the holder accuracy.
■Cutting conditions for two or more tools can be entered
The twelve cutting conditions such as pressure, speed, start/end point correction, offset, etc. can be entered
separately for two or more tools.
To Next Page
Loading...
