CHAPTER 1
SET-UP
This chapter describes the procedure to be taken after the unpacking to specify functionsthat
are required for the connection of this device to your computer.
Table of Contents
INSTALLATION SITE
.......................................................................................................................................................1-2
EFFECTIVE CUTTING AREA
......................................................................................................................................1-4
CHECKING THE ACCESSORIES
...............................................................................................................................1-5
CONFIGURATION AND FUNCTION
.......................................................................................................................1-6
CONNECTING THE CABLES
................................................................................................................................... 1-11
TURNING THE POWER ON/OFF
........................................................................................................................... 1-14
EMERGENCY STOP
......................................................................................................................................................1-15
LOCAL/REMOTE MODES
.......................................................................................................................................... 1-17
Matching the functions of the device to the specifications of the computer
............................................... 1-19
Matching the specifications on the plotter’s side
.................................................................................................1-24
Setting for automatic head retract [AUTO VIEW]
..............................................................................................1-25
AUTO-OFF FEATURE OF THE VACUUM
......................................................................................................... 1-27