BASIC OPERATION ON THE LOCAL MENU
2-3
ORIGIN A command origin is established that matches your CAD.
P. 1-22
Z STROKE The height of the tool, in its lifted position, from the surface of a work
to the bottom of tool is specified.
P. 4-10
OH UNIT A value that is transmitted to the computer in return to the command
for the output of effective area coordinate of the device.
P. 1-21
ROTATE A direction in which data transmitted from application software are to
be turned by 90 is specified.
P. 4-9
COMMAND SW The set values that are rendered effective are specified either those set
on the operation panel or those set on the personal computer.
P. 1-20
PEN ASSIGN Pen numbers included in data are assigned to tools of the device.
P. 4-2
MULTI-PASS The number of times to perform cutting is set when cutting a work that
cannot be cut by performing cutting once.
P. 4-6
VACUUM Setup the validity of the auto-off function.
P. 1-27
EXPAND When Mark sensor is not used, expand the cut area of x-axis up to
30mm
P. 4-15
MARK SENSOR Set up the register mark detect setting
P. 5-10
To Next Page
Loading...
Need help?
General
