2-26
Press correction: 0 to 1000 (in increments of 100 g)
Press (Y): –5000 to 5000 (in increments of 100 g)
Cutting conditions for the swivel blade
The following gives set values for cutting conditions for the swivel blade (optional).
Set values
Speed: 0.2, 0.5, 1, 2, 5, 10, 15, 20, 25, 30 (cm/s)
Pressure: 20 to 100 (in increments of 5 g)
100 to 400 (in increments of 10 g)
Offset: 0.00 to 2.50 (in increments of 0.05 mm)
Acceleration: 0.1 to 0.3 (in increments of 0.1 G)
To Next Page
Loading...
