MIMAKI CF2 Series - CHAPTER 3 WHEN ABNORMAL CONDITIONS ARE ENCOUNTERED; IF ANY OF THE BELOW-STATED PHENOMENA TAKES PLACE; TOOLS ARE NOT ALIGNED TO EACH OTHER [TOOL SELECT]; TROUBLES FOR WHICH ERROR MESSAGES ARE GIVEN ON THE LCD

CHAPTER 3
WHEN ABNORMAL CONDITIONS ARE
ENCOUNTERED
This chapter describes how to correct troubles in the event that desired cutting results are not
obtained or a failure has occurred.
Table of Contents
IF ANY OF THE BELOW-STATED PHENOMENA TAKES PLACE .............................................................3-2
Tangent line Tangent lineCorrugated board is cut out at flutes though creasing is performed
[CONDITION] > [PRESS (Y)]
.....................................................................................................................................3-4
TOOLS ARE NOT ALIGNED TO EACH OTHER [TOOL SELECT] ..............................................................3-6
IF THERE IS A SIGN OF FAILURE ........................................................................................................................3-15
TROUBLES FOR WHICH ERROR MESSAGES ARE GIVEN ON THE LCD ..........................................3-17