MIMAKI UJF-3042 - Page 20

1
2
3
4
5
6
7
8
© 2011 MIMAKI ENGINEERING CO.,LTD. 1.2.7 R.2.0 P.1
Maintenance Manual > Operating Principle > Maintenance Function > NOZZLE WASH
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.
1.2.7 NOZZLE WASH
 Indication on LCD
 Processing sequence
For other than the “service mode”, to prevent dryness of the nozzle surface and inside the cap, the warning sound
beeps at intervals of 30 seconds during carriage out.
STEP. Processing Description
1Start
1. The Y bar comes to the front.
2. Performs cap OFF and moves the head to the maintenance position.
3. The wiper comes to the front.
2 Performing maintenance
(Indicate 1)
1. The wiper pump operates periodically while maintenance is being performed.
2. Message of maintenance is completed is displayed. Terminate with the [ENTER].
3 Entering leaving time
(Indicate 2)
1. The wiper returns to the wiper origin position (aftermost).
2. The head caps ON.
3. The Y bar returns to the back.
4. Select the leaving time with the[5] [6] keys.
5. When you press the [ENTER] key, it enters in the waiting mode for the set leaving
time.
4 Waiting for leaving time
(Indicate 3)
1. It does not move with cap ON for the set leaving time.
2. After the set leaving time has passed, performs cleaning.
5 Cleaning
(Indicate 4)
1. Performs normal cleaning once.
2. By cleaning is terminated, nozzle cleaning is completed.
MAINTENANCE
STATION <ENT>
STATION
MENT :NOZZLE WASH
STATION
HEAD [123]
Fill the liquid.
COMPLETED <ENT>
STATION
LEAVING : **min
STATION
LEAVING hh:mm
CLEANING ACTIVE
***---------------
Indicate 1
Indicate 2
Indicate 3
Indicate 4