Mindray Hepatus 7 User Manual

11 Measurement and Report
Operator’s Manual 11 - 11
7. Tap on the screen twice to anchor the last reference point. The spline is fixed and the results
display in the results window.
Cross
Perform the following procedure:
1. Select [Cross] in the measurement menu.
The cursor appears on the screen.
2. Move the cursor to an area of interest.
3. Tap on the screen to fix the starting point of the first axis.
4. Move the cursor to position the end point of the first axis and then:
– Tap [Update] to switch between the start point and the end point of the first axis. Or
– Tap [Clear All] to clear all calipers.
5. Tap on the screen to set the end point of the first axis. The second axis (perpendicular to the
first axis) of the cross appears on the screen.
6. Move the cursor and tap on the screen to fix the starting point of the second axis.
7. Move the cursor to the end point of the second axis. Then
– Tap [Update] to switch between the start point and the end point of the first axis. Or
– Tap [Clear All] to clear all calipers.
8. Tap on the screen to set the end point of the second axis and fix the region. The results appear
in the result window.
11.3.11Time
Measures the time interval between two points on the M/Doppler Mode image.
Perform the following procedure:
1. Select [Time] in the measurement menu.
The cursor appears in the center of the screen.
2. Move the cursor of the dotted lines to the measurement starting point and tap on the screen.
3. Move the cursor to the measurement end point. The cursor can only be moved in a horizontal
direction. Then
– Tap [Update] to switch between the fixed end and active end of the caliper. Or
– Tap [Clear All] to clear all calipers.
4. Tap on the screen to set the end point.
11.3.12Slope
Measures the distance and time between two points on the M Mode image and calculates the slope
between the two points.
Perform the following procedure:
1. Select [Slope] in the measurement menu. Two dotted lines perpendicular to each other appear
on the screen.
2. Move the cursor of the dotted lines to the measurement starting point and tap on the screen.
3. Move the cursor to the measurement end point. The cursor is connected to the starting point by
a dashed line. Then
– Tap [Update] to switch between the fixed end and active end of the caliper. Or
– Tap [Clear All] to clear all calipers.

Mindray Hepatus 7 Specifications

General

Brand	Mindray
Model	Hepatus 7
Category	Medical Equipment
Language	English