Minebea Intec PR5900 - Page 222

WP-C Max -------?? d= -------??
Arith err.
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
Mettler-Scale
Pendeo Process
Parameters
WP-C Max -------?? d= -------??
Arith err.
Weighing points @admin
Weighing point C
Settings locked
W&M
Max
Scale interval
Minimum weight
Mettler-Scale
none
1000 kg
1
0 d
Default Save
[Settings locked]
The weighing point settings and assignment can only be viewed as if the
corresponding CAL switch were closed; see Chapter 2.7.1.
[W&M]
Setting for operation in legal metrology.
Selection: [None], OIML, NTEP (for USA) or NSC (for Australia), see Chapter 4.7.1.1.1.
[Max]
Enter the maximum capacity of the Mettler-Scale with decimal places and the weight
unit.
Setting range: 0.000001…9999999 in mg, kg, t
[Scale interval]
The scale interval (d) is the dierence between two successive display values.
See Chapter 4.7.1.2.1.2.
[Min. weight]
Minimum weight at which a print command can be triggered.
Setting range: 0…9999999 d.
1. In this case: Select [Weighing point C] with [Mettler-Scale] and press the [Parameters]
soft key.
A selection window opens.
2. Select and conrm the individual parameters.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-220