Minebea Intec X3 Process Indicator PR 5410 User Manual

This ensures that a valid address for identication of the device in the network can be
assigned to the device from a server, see also Chapter 7.17.6.
Note:
The last 3 bytes of the MAC ID are displayed. A label with the complete MAC ID is located
on the outside of the device.
If the device is connected to an IT network (company network) with an DHCP server and
was activated under - [Network parameter] of the "Use DHCP" parameter (default/
factory setting), it does not require further actions except for a 23-minute waiting time.
Subsequently, a network connection is established automatically (device <->
workstation/PC).
7.11 Operation using VNC
VNC (on the enclosed CD-ROM) stands for "virtual network computing" and is a program
for remote operation of computers.
The program distinguishes between the VNC server and VNC client (viewer). The server
program is part of the device software, the client program (viewer) must be run on the
notebook/PC in order to operate the device.
Note:
The VNC version provided on CD must be used. More recent VNC versions (freeware)
from the internet are not supported by the device!
For direct operation using the VNC program, the IP address (extended by :1) must be
specied when you run the program, e.g., 172.24.20.233:1.
Note:
In the device, the VNC access to certain notebooks/PCs can be limited, see
Chapter 7.17.6.
7 Commissioning X3 Process Indicator PR 5410
EN-147 Minebea Intec

Minebea Intec X3 Process Indicator PR 5410 Specifications

General

Brand	Minebea Intec
Model	X3 Process Indicator PR 5410
Category	Touch Panel
Language	English