Minebea Intec X3 Process Indicator PR 5410 - Printing Parameter; Fieldbus Parameter; Network Parameter

— Address Device address, e.g. for the printout
Input: AZ
— PIN Access code, to protect the system setup from
unauthorized operation.
Input: 6 numerical characters
— Sequence number Automatic counter for print jobs
— SetTareKey Tare key
Selection: Tare&reset tare, tare&tare again,
disabled
— SetZeroKey Zero-setting key
Selection: only when not tared, reset tare on
zeroset, disabled.
— Printing mode Printing mode
Selection: Triggered (trigger one printout),
Cyclic, Cyclic with enable
— Printing interval Printing interval
This menu item only appears if the [Cyclic] or
[Cyclic with enable] printing mode has been
selected.
Input: 1250
— Printing interval unit Unit of the printing interval
Selection: Seconds, Minutes, Hours, Meas. time
— Printlayout Item 16 Print layout for line 16; see Chapter 7.17.4.
— Fieldbus protocol
— HW address MAC-ID, display: e.g.: 00:90:6C:31:1F:55
— Hostname
Unique device name, input: 224
alphanumerical characters
— Use DHCP Check the ☑ box to activate DHCP.
— IP address IP address, display: network address assigned
by the server
— Subnet mask Subnet mask, display: Mask for valid IP address
range
— Default gateway Standard gateway, display: IP number for
gateway
— Remote access Remote access to VNC client
— VNC client
7.13.4 Printing parameter
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.13.5 Fieldbus parameter
7.13.6 Network parameter
X3 Process Indicator PR 5410 7 Commissioning
Minebea Intec EN-150