Minebea Intec X3 Process Indicator PR 5410 - Deleting the PIN Code Using the Front-Panel Keys; Entering Fieldbus Parameters Using the Front-Panel Keys

7.5.8 Deleting the PIN code using the front-panel keys
7.5.9 Entering eldbus parameters using the front-panel keys
Example:
Fieldbus card PR 1721/36 ProNet I/O
1. Press .
SEtuP appears on the display.
2. Press OK.
PIn appears on the display.
3. Press OK.
000000 appears on the display.
4. Press the cursor keys to enter the PIN code.
5. Press OK to save the PIN code.
6. Press OK.
The "Cd" calibration menu ashes.
Cd 000 appears on the display.
7. Press multiple times to select "oP."
oP 060 appears on the display.
8. Press to change the parameter number ("000" ashes).
9. Press to select the parameter number.
oP 061 appears on the display.
10. Press OK.
PIn appears on the display.
11. Press OK.
The PIN code appears on the display.
12. Press the cursor keys to enter PIN code "000000" (=no prompt).
13. Press OK to save the entry.
1. Press .
SEtuP appears on the display.
2. Press OK.
Cd 000 appears on the display.
7 Commissioning X3 Process Indicator PR 5410
EN-137 Minebea Intec