Minebea Intec X3 Process Indicator PR 5410 - Restart; Switching on the Device

* Parameter [W&M] must be set to [none] before the calibration data is entered; see
Chapter 7.14.15.
7.1.4 Restart
The PR 5410 is restarted using the front-panel keys.
Press the following keys one after the other:
-
SEtuP appears on the display.
- /
bIoS appears on the display.
- /OK
bIoS... appears on the display.
FLASH follows on the display.
- /
boot appears on the display.
- /OK
Restarting has the following eects on the device:
- Current process steps are deleted.
- The device is reset to its factory settings.
- The network settings are not changed.
7.2 Switching on the device
The device can be set up as follows:
- Via keys on the front of the device
- Via a notebook/PC using the VNC software (included on the CD)
- Via a notebook/PC using an Internet browser
As soon as the device is provided with power, the display shows:
Pr5410 Message with device type PR 5410
b 1.00.00. BIOS version
7 Commissioning X3 Process Indicator PR 5410
EN-121 Minebea Intec