Minebea Intec X3 Process Indicator PR 5410 - Configuring Material

Note:
The SPM address %MX for an unused digital input = 0.
Note:
The SPM address %MX for an unused digital output = 0.
8.4.3 Conguring material
The materials (products) 110 are congured under the [Conguration material] menu
item.
4. Press to exit the window and to save the changes.
5. Select [Conguration digital outputs] and conrm.
6. Select outputs 13. Use the keypad to enter and conrm a corresponding SPM
address %MXxxx (see Chapter 13.4).
7. Press to exit the window and to save the changes.
8 Production X3 Process Indicator PR 5410
EN-259 Minebea Intec