Minebea Intec X3 Process Indicator PR 5410 - 8 Production; General Notes; Configuration Using the Front-Panel Keys; Configuring Production Mode Using the Front-Panel Keys

8 Production
8.1 General notes
All lling functions are only supported by the "EasyFill" application.
NOTICE
Data is lost if the power is interrupted.
There are hard drives for 10 material data records available, which are retained after a
power failure.
It is important to save material data.
8.2 Conguration using the front-panel keys
The production parameters can be congured directly using the front-panel keys.
8.2.1 Conguring production mode using the front-panel keys
You can select between the following production modes:
- Net lling (B1)
- Net Discharge (B4)
Note:
See also Chapter 8.4.1.
1. Press .
SEtuP appears on the display.
2. Press OK.
The "Cd" calibration menu ashes.
Cd 000 appears on the display.
3. Press multiple times to select "CA 150."
4. Press OK.
dModE appears on the display.
5. Press OK.
nE.t (Net lling, B1) appears on the display.
6. Press if necessary, to select "ne.t d.l." (net discharge, B4).
7. Press "Exit" to exit the Setup menu.
8 Production X3 Process Indicator PR 5410
EN-247 Minebea Intec