Minebea Intec X3 Process Indicator PR 5410 User Manual

*
An error message appears if the digit group for the IP address/mask is not within 0–255,
or is invalid.
7.5.10 Entering the network address using the front-panel keys
Note:
A new address may be assigned by the server in the event of a restart.
19. Press OK.
YES appears on the display.
20. Press OK.
SAVE ... appears on the display during the save process.
21. Press "Exit" to exit the Setup menu.
1. Press .
SEtuP appears on the display.
2. Press OK.
The "Cd" calibration menu ashes.
Cd 000 appears on the display.
3. Press multiple times to select "nP 080."
4. Press OK.
dHCP (DHCP) appears on the display.
5. Press OK.
DHCP is activated. The network address is assigned automatically.
If DHCP is not activated ("oFF"), the addresses must be entered manually.
on appears on the display.
6. Press OK.
nP 081 appears on the display.
7. Press OK.
IP.Addr appears on the display.
8. Press OK.
7 Commissioning X3 Process Indicator PR 5410
EN-139 Minebea Intec

Minebea Intec X3 Process Indicator PR 5410 Specifications

General

Brand	Minebea Intec
Model	X3 Process Indicator PR 5410
Category	Touch Panel
Language	English