Minebea Intec X3 Process Indicator PR 5410 - Searching Load Cells

- Recalibrate: Maximal load with weight unit, scale interval, dead load, CAL weight, see
Chapter 7.16.7.
- Perform a corner correction if necessary; see Chapter 7.16.10.3.
Note:
For further information about calibrating weighing points, see Chapter 7.14.3.
7.16.5 Searching load cells
1. Select -[Weighing point]- [Weighing point A].
2. Press the [Assign] softkey.
The following window opens:
3. Press the [Search] softkey.
X3 Process Indicator PR 5410 7 Commissioning
Minebea Intec EN-196