Minebea Intec X3 Process Indicator PR 5410 - Resetting the Device to the Factory Settings

9.4 Resetting the device to the factory settings
Note:
Reset to the factory settings is possible only, when the CAL switch is open. The IP
address and the Hostname remain unaected.
1. Press .
SEtuP appears on the display.
2. Press .
bIoS appears on the display.
3. Press OK.
FLASH follows on the display.
bIoS... appears on the display.
4. Press 2×.
dEL.EAr. appears on the display.
5. Press OK.
ErAS.E? and then no appear on the display.
6. Press .
YES appears on the display.
7. Press OK.
donE appears on the display once the process is complete.
8. Press to restart the device.
1. Click on .
2. Click on .
The following prompt window appears:
X3 Process Indicator PR 5410 9 Extended functions
Minebea Intec EN-280