Minebea Intec X3 Process Indicator PR 5410 User Manual

9.5.1.2 Loading the software on your notebook/PC
9.5.2 Updating via a point-to-point connection with DHCP service
Requirements:
- Device and notebook/PC are connected to each other.
- The automatic address assignment "DHCP" is activated in the device and in the
notebook/PC; see Chapter 7.17.6.
- The "FlashIt!32" program (in a directory on the enclosed CD-ROM) is installed on the
notebook/PC.
- The "FlashIt!32" program is started.
7. Make sure to note down the digit sequence, because it must be entered into the
"FlashIt!32" window subsequently.
Now the device is ready to load the software.
FLASH? appears on the display.
1. Click the relevant le in the "Explorer" with the mouse and drag it into the [Select]
window, (or use 'Copy and paste').
2. Under [COM-Port] select "Network" and enter the devices IP addresses.
3. Click [Flash] to start the procedure.
As soon as software loading is completed the device will be re-started.
4. Load next le, as described.
9 Extended functions X3 Process Indicator PR 5410
EN-283 Minebea Intec

Minebea Intec X3 Process Indicator PR 5410 Specifications

General

Brand	Minebea Intec
Model	X3 Process Indicator PR 5410
Category	Touch Panel
Language	English