Minebea Intec X3 Process Indicator PR 5410 - Network Parameters

NOTICE
Potential network problems
A unique device name must be assigned for the hardware conguration and
assignment/download.
Note:
See Chapter "Description of the I/O Area"
Example:
The gross weight should be read.
I/O size = 8 bytes, counted from byte 0–7
7.17.5.4 EtherNet-IP settings for Rockwell workstation
Requirements:
- PR 1721/37 DeviceNet EtherNet-IP is installed.
Procedure:
Note:
Further details can be found in the supplementary application manual "How to"
(available upon request from technical.support.hh@minebea-intec.com).
Note:
See Chapter "Description of the I/O Area"
Example:
The gross weight should be read.
I/O size = 8 bytes, counted from byte 0–7
7.17.6 Network parameters
Under this menu item, you can dene the network parameters for the network
connections (built-in LAN adapter).
2. Enter the IP address and network mask under - [Fieldbus parameter] and
conrm.
3. Add the PR 5410 device to the project and assign the I/O ranges.
4. Assign the instrument name to the PR 5410.
1. Enter the IP address and network mask under - [Fieldbus parameter] and
conrm.
2. Register the le "sag_5410_Ethernetip.eds" using the "Hardware Installation Tool".
3. Select and insert the instrument from the catalog into the I/O conguration.
7 Commissioning X3 Process Indicator PR 5410
EN-223 Minebea Intec