Minebea Intec X3 Process Indicator PR 5410 - Date and Time

7.17.2 Date and time
The date and time are set under this menu item.
The selected interface is displayed.
3. Press the [Param] softkey to set the parameters.
The following window opens:
4. Select [Baudrate] and conrm.
A selection window opens.
5. Select the desired transmission speed and conrm.
6. Select [Stopbits] and conrm.
A selection window opens.
7. Select the desired stopbit and conrm.
8. Press two times to exit the menu and save.
7 Commissioning X3 Process Indicator PR 5410
EN-215 Minebea Intec