Minebea Intec X3 Process Indicator PR 5410 User Manual

— Service The service window for the load cells is
displayed. No change is possible!
— Limit 13 on
Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 13, clr
(clear) marker 13
— Condition Condition, selection: see Chapter 7.17.7.
— Limit 13 o
Enter 0 – Max (maximum load); take unit from
calibration.
— Action
Action, selection: no action, set marker 13, clr
(clear) marker 13
— Condition Condition, selection: see Chapter 7.17.7.
— Output 1…3 Congure outputs, selection: see
Chapter 7.17.9.
— Input 1…3 on Congure inputs
— Action Action, selection: see Chapter 7.17.8.1.
— Condition Condition, selection: see Chapter 7.17.8.2.
— Input 1…3 o Congure inputs
— Action Action, selection: see Chapter 7.17.8.1.
— Condition Condition, selection: see Chapter 7.17.8.2.
— Analog mode Analog output parameter: Gross D08 = gross,
Net if tared D09 = Net if tared, Selected D11 =
value on the display, Transparent D30 =
Transparent, no output = analog output
unused, see Chapter 7.17.10.
— Analog range
Output range: 020 mA, <420 mA>
— Output on error Output on error: 0 mA = set to 0 mA, <4 mA> =
set to 4 mA, 20 mA = set to 20 mA, hold = last
output value remains unchanged
— Output if <0
7.13.8 Limit parameter
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.13.9 Digital I/O parameters
Note:
This menu item is only available if under -[Operating parameter]- [Application]
"Standard" has been selected.
7.13.10 Analog output parameter
7 Commissioning X3 Process Indicator PR 5410
EN-157 Minebea Intec

Minebea Intec X3 Process Indicator PR 5410 Specifications

General

Brand	Minebea Intec
Model	X3 Process Indicator PR 5410
Category	Touch Panel
Language	English