Minebea Intec X3 Process Indicator PR 5410 User Manual

Bytes 063
Name Type of data Function
Byte 2 Bit 0: reset power failure (power
fail)
Bit 1: reset error
Bit 2: weights as DINT
Bit 3: zero
Bit 4: tare
Bit 5: reset tare
Bit 6: lling mode
Bit 7: read material from the
material table
BOOL Bit 0:
rising edge
Bit 1:
rising edge: resets the error ag and error
code.
Bit 2:
status-controlled:
Value: 0 = Real, 1 = DINT
Bit 3:
rising edge
Bit 4:
rising edge
Bit 5:
rising edge
Bit 6:
status-controlled: 0 = ll, 1 = empty
Bit 7:
rising edge: A valid material ID is required
in byte 3. Filling does not start.
This function can be used to display materi-
al parameters on external displays.
Byte 3 Material ID BYTE
Value range: 110
Byte 47
Set point DINT/REAL Weight
Byte 811
Preset DINT/REAL Preset point for switching from coarse ow
to ne ow.
Byte 1215
Material overshoot (OVS) DINT/REAL Weight
Byte 1619
Calming time DINT [ms]
Byte 2023
Tolerance above set point DINT/REAL Weight
Byte 2427
Tolerance below set point DINT/REAL Weight
12.3.5.2 Read window EasyFill → PLC
The data required for monitoring and controlling lling does not t in a 64-byte write
window. For this reason the system dierentiates between system and material
parameters. The value of the rst byte can be used to determine whether the data refers
to the system or the material.
12.3.5.2.1 System data
Before starting lling, a check must be carried out to ensure that the system is ready
(byte 3: bit 2).
The Dosing_Run bit is set once lling has successfully started.
Bytes 063
Name Type of data Function
Byte 0 TableSelect USINT Content of read data:
0 = system data, 1 = material data
12 Fieldbus interface X3 Process Indicator PR 5410
EN-309 Minebea Intec

Minebea Intec X3 Process Indicator PR 5410 Specifications

General

Brand	Minebea Intec
Model	X3 Process Indicator PR 5410
Category	Touch Panel
Language	English