MKS 146C - Page 308

Chapter Nine: RS-232 Communications Command Messa
g
es
285
Response Format for the Read Only Status Messages (Continued)
Message Response Description
Rear Panel Status
Remote zero channel 1
Remote zero channel 2
Remote zero channel 3
Remote zero channel 4
Latch relay A
Latch relay B
Latch relay C
Latch relay D
Front panel lockout
Open valve
Manual valve control
Close valve
Set point B
Set point C
Set point D
RZ1:<text> LF CR
RZ2:<text> LF CR
RZ3:<text> LF CR
RZ4:<text> LF CR
LTA:<text> LF CR
LTB:<text> LF CR
LTC:<text> LF CR
LTD:<text> LF CR
FPL:<text> LF CR
OM:<text> LF CR
MM:<text> LF CR
CM:<text> LF CR
SPB:<text> LF CR
SPC:<text> LF CR
SPD:<text> LF CR
where <text> is L for low (Ground)
H for high (5 Volts)
Calibration Data (ASCII) <text> LF CR
<text> LF CR
<text> LF CR
<text> LF CR
<text> LF CR
where <text> is a six character value for
the voltage in standard fixed point
format. The second character from the
left is the decimal point.
* All response messages terminate in a CR as the end-of-line delimiter
Table 83: Response Format for the Read Only Status Messages
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com