Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-291
Table 3-194: +CME Errors
<Parameter> Description
<err> Numeric format followed by verbose format:
0, "phone failure"
1, "no connection to phone"
2, "phone-adaptor link reserved"
3, "operation not allowed"
4, "operation not supported"
5, "PH-SIM PIN required"
6, "PH-FSIM PIN required"
7, "PH-FSIM PUK required"
10, "SIM not inserted"
11, "SIM PIN required"
12, "SIM PUK required"
13, "SIM failure"
14, "SIM busy"
15, "SIM wrong"
16, "incorrect password"
17, "SIM PIN2 required"
18, "SIM PUK2 required"
20, "memory full"
21, "invalid index"
22, "not found"
23, "memory failure"
24, "text string too long"
25, "invalid characters in text string"
26, "dial string too long"
27, "invalid characters in dial string"
30, "no network service"
31, "network timeout"
32, "network not allowed - emergency calls only"
33, "command aborted"
34, "numeric parameter instead of text parameter"
35, "text parameter instead of numeric parameter"
36, "numeric parameter out of bounds"
37, "text string too short"
40, "network personalization PIN required"
41, "network personalization PUK required"
42, "network subset personalization PIN required"
43, "network subnet personalization PUK required"
44, "service provider personalization PIN required"
45, "service provider personalization PUK required"
46, "corporate personalization PIN required"
47, "corporate personalization PUK required"
60, "SIM service option not supported"
100, "unknown"
103, "Illegal MS (#3)"
106, "Illegal ME (#6)"
107, "GPRS services not allowed (#7)"
To Next Page
Loading...
