AT Commands Alphabetical Summary
A-12 AT Commands Reference Manual December 31, 2007
+ICF
This command determines the
local serial port start/stop
(asynchronous) character framing
used by the DCE when accepting
DTE commands and transmitting
information text and result codes,
whenever these are not done
automatically.
Page 3-205
+IFC
This command controls the
operation of the local flow
control between the terminal and
the G24.
Page 3-430
+IPR
This command is responsible for
setting and saving the request
baud rate.
Page 3-195
+MADIGITAL
This command switches between
analog and digital audio modes.
Page 3-244
+MAFEAT
This command controls the
various algorithm features, such
as sidetone, echo cancel and
noise suppress.
Page 3-243
+MALARM
This unsolicited event is sent to
the terminal indicating a
reminder is activated.
Page 3-86
+MALMH
This command terminates the
current reminder.
Page 3-87
+MAMUT
This command controls the
muting/unmuting of all input
paths (MIC, HDST_MIC,
DIGITAL_RX).
Page 3-242
+MAPATH
This command sets/requests the
active input accessory, and the
output accessory for each feature.
Page 3-237
+MAVOL
This command enables you to
determine a volume setting for a
particular feature in a particular
accessory.
Page 3-240
+MCEG
This command disables / enables
EDGE support in G24 modules
with EDGE support capability.
Page 3-356
+MCELL
This command displays
information about the Cellular
Network.
Page 3-179
+MCSAT
This command
enables/disables/exercises SMS
alert tone for an arriving SMS.
Page 3-137
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
Need help?
General
