Appendix A: Reference Tables
December 31, 2007 AT Commands Reference Manual A-15
+MGGIND
This command configures the
service indicator on pin 49 of the
70 pin connector to be GPRS or
GSM.
Page 3-203
+MHDPB
This command is used to enable
and disable the SEND/END
functionality of the headset
dual-position button.
Page 3-318
+MHUP
This command Hung UP call(s)
and report specific cause to the
NW.
Page 3-42
+MIAU
This command manages IP
Director addresses and port.
Page 3-338
+MIOC
This command defines the
G24 8 GPIO pins data value.
Page 3-213
+MIOD
This command defines the
G24 8 GPIO pins
configuration.
Page 3-217
+MIPCALL
This command creates a wireless
PPP connection with the GGSN,
and returns a valid dynamic IP
for the G24.
Page 3-386
+MIPCFF
This command allows
configuring the incoming TCP
connection filtering feature
parameters, such as list of
allowed IP addresses or
disabling/enabling the filtering.
Page 3-417
+MIPCLOSE
This command causes the G24
module to free the socket
accumulating buffer and
disconnect the G24 from a
remote side.
Page 3-392
+MIPCONF
This command allows to
configure TCP stack parameters,
such as retransmissions number,
upper and bottom limits of
retransmission timeout, close
delay.
Page 3-403
+MIPCSC
This AT command is used to
configure the SSL feature
behavior in case of non - fatal
alerts.
Page 3-414
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
Need help?
General
