Appendix A: Reference Tables
December 31, 2007 AT Commands Reference Manual A-21
Q
This command determines
whether to output/suppress the
result codes.
Page 3-274
READY
This unsolicited notification
indicates UART is ready.
Page 3-211
RING
This unsolicited event is received
when an incoming call (voice,
data or fax) is indicated by the
cellular network.
Page 3-19
S102
This S-register sets the value of
the delay before sending the data
to the terminal.
Page 3-286
S24
This S-parameter
activates/disables the Sleep
mode. If the parameter value is
greater than 0, it represent the
number of seconds till the G24
enters sleep mode.
Page 3-285
S94
This S-parameter represents the
Boolean status, On/Off, of the
sidetone feature.
Page 3-235
S96
This S-parameter represents the
Boolean status, On/Off, of the
echo cancelling feature in the
handsfree.
Page 3-236
Sn
This command reads/writes
values of the S-registers, and
includes registers 1-49.
Page 3-277
T
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
V
This command determines the
response format of the data
adapter and the contents of the
header and trailer transmitted
with the result codes and
information responses.
Page 3-273
X
This command defines the data
adaptor response set, and the
CONNECT result code format.
Page 3-276
Y
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
Z
This command resets the default
configuration.
Page 3-282
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
Need help?
General
