EasyManuals Logo

Motorola G24 Guide User Manual

Motorola G24 Guide
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
Chapter 1: Product Features
December 31, 2007 AT Commands Reference Manual 1-29
+MFOTAWSCF
G
This command sets the Web-Session default entry.
Page 3-265
+MFOTACNFG This command enables setting the DM session as
Automatic/Non-Automatic (i.e. Transparent/Non-Transparent).
Page 3-266
+MFOTAREQ This command sends FOTA requests toward DTE.
Page 3-268
+MFOTARSP This command is used to send response to +MFOTAREQ reports.
Page 3-269
+MFOTAINSTL Installs the updated package.
Page 3-270
+MFOTAABOR
T
Aborts the DM session.
Page 3-270
+MFOTAIND This command sends Unsolicited FOTA indications toward DTE.
Page 3-271
Modem Configuration and Profile
Modem Register Commands
V This command determines the response format of the data adapter
and the contents of the header and trailer transmitted with the result
codes and information responses.
Page 3-273
Q This command determines whether to output/suppress the result
codes.
Page 3-274
E This command defines whether the G24 echoes the characters
received from the user, (whether input characters are echoed to
output).
Page 3-275
X This command defines the data adaptor response set, and the
CONNECT result code format.
Page 3-276
Sn This command reads/writes values of the S-registers, and includes
registers 1-49, 94, 96 (Audio) and 102 (Sleep mode).
Page 3-277
\S This command displays the status of selected commands and
S-registers.
Page 3-280
\G This command sets the use of the software flow control.
Page 3-280
\J This command adjusts the terminal auto rate.
Page 3-280
\N This command displays the type of link.
Page 3-280
? This command displays the most recently updated value stored in
the S-register.
Page 3-281
&F This command restores the factory default configuration profile.
Page 3-281
Z This command resets the default configuration.
Page 3-282
Sleep Mode Commands
S24 This S-parameter activates/disables the Sleep mode. If the parameter
value is greater than 0, it represent the number of seconds till the
G24 enters sleep mode.
Page 3-285
Table 1-1: AT Commands (Cont.)
AT Command Description Page

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola G24 Guide and is the answer not in the manual?

Motorola G24 Guide Specifications

General IconGeneral
BrandMotorola
ModelG24 Guide
CategoryTelephone Accessories
LanguageEnglish

Related product manuals