AT Commands Summary
1-34 AT Commands Reference Manual December 31, 2007
M This command is supported for backward compatibility only, and
has no effect.
Page 3-422
N This command is supported for backward compatibility only, and
has no effect.
Page 3-422
P This command is supported for backward compatibility only, and
has no effect.
Page 3-422
T This command is supported for backward compatibility only, and
has no effect.
Page 3-422
Y This command is supported for backward compatibility only, and
has no effect.
Page 3-422
+FAR This command is supported for backward compatibility only, and
has no effect.
Page 3-423
+FCL This command is supported for backward compatibility only, and
has no effect.
Page 3-423
+FDD This command is supported for backward compatibility only, and
has no effect.
Page 3-423
+FIT This command is supported for backward compatibility only, and
has no effect.
Page 3-423
Fax Class 1
Fax Commands
+FCLASS This command places the terminal in particular mode of operation
(data, fax, voice).
Page 3-424
+FTS This command causes the G24 to stop any transmission.
Page 3-425
+FRS This command causes the G24 to listen and to report back an OK
result code when the line has been silent for the specified amount of
time.
Page 3-425
+FTM This command causes the G24 to transmit data.
Page 3-426
+FRM This command causes the G24 to enter the receive mode.
Page 3-428
+FTH This command causes the G24 to transmit data framed in the HDLC
protocol.
Page 3-428
+FRH This command causes the G24 to receive HDLC framed data and
deliver the next received frame to the terminal.
Page 3-430
+IFC This command controls the operation of the local flow control
between the terminal and the G24.
Page 3-430
+FPR This command sets the request baud rate.
Page 3-432
Table 1-1: AT Commands (Cont.)
AT Command Description Page
To Next Page
Loading...
