Chapter 1: Product Features
December 31, 2007 AT Commands Reference Manual 1-33
+MSDNS This command set/read DNS IP address for each socket.
Page 3-412
+MIPCFF This command allows configuring the incoming TCP connection
filtering feature parameters, such as list of allowed IP addresses or
disabling/enabling the filtering.
Page 3-417
+MIPCSC This AT command is used to configure the SSL feature behavior in
case of non - fatal alerts.
Page 3-414
+MIPSSL This unsolicited event is sent to the terminal indicating an errors,
warnings or alerts that occurred during SSL connection.
Page 3-419
NOP Compatible
Ignored (Compatible Only) Commands
%C This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&G This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&J This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&L This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&M This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&P This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&Q This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&R This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&S This command is supported for backward compatibility only, and
has no effect.
Page 3-422
&T This command is supported for backward compatibility only, and
has no effect.
Page 3-422
\B This command is supported for backward compatibility only, and
has no effect.
Page 3-422
\A This command is supported for backward compatibility only, and
has no effect.
Page 3-422
\K This command is supported for backward compatibility only, and
has no effect.
Page 3-422
F This command is supported for backward compatibility only, and
has no effect.
Page 3-422
L This command is supported for backward compatibility only, and
has no effect.
Page 3-422
Table 1-1: AT Commands (Cont.)
AT Command Description Page
To Next Page
Loading...
