3-47
3.4 Setting individual autodialer attributes
This function allows the user to configure an individual address book entry with the settings shown in Memory
Switches 010, 011, 012, 013 and 014.
To set the individual attributes:
1. Change memory switch 15, bit 7 to “1”. (See “3.3.1 Setting the Memory Switches” for more information on
changing memory switch 015.)
2. When the function is enabled, an “Attribute” option is added to the address book destination registration
steps. As an address book destination is programmed, an extra step showing Attribute 1, Attribute 2,
Attribute 3, Attribute 4, and Attribute 5 are added as the last step.
3. Set the individual bit positions as shown in the following table. To change a setting, press or until the
cursor is below the desired bit position; then press “1” or “0” to make the change.
4. Press [Enter] to save the setting of the displayed attribute and advance to the next attribute.
5. To set the other attribute, repeat steps 3-4.
6. When the last attribute is set, the fax will advance to the next autodialer programming steps.
7. When all the desired individual attributes are set, reset memory switch 15, bit 7 to “0”. (See “3.3.1 Setting
the Memory Switches” for more information on changing memory switch 015.)
To Next Page
Loading...
Need help?
General
