2-19
Fusing temperature
1) Warming Up After the initialization of the printer, warming up of the printer starts and the Heater Lamp
turns ON until the temperature of the Heater Roller reaches approx. 170 °C.
2) Printing When the printer obtains the printing command from its controller, the Heater Roller is main-
tained at 180 °C.
After printing, the printer turns to ready mode. The fuser kept at low temperature.
3) Ready The Heater Roller maintained at approx. 80 °C.
4) Energy save mode In this mode, saving the power.
( F) ( C)
Power ON
Warming up
Time
Printing
Ready mode
180
80
365
176
Energy save mode