3-52
3.5.2 Clearing the unique switches
Resets the unique switches to factory defaults.
1. From standby, press <Mode>, <*>, <0>, <4>.
2. Press [Switch Clear].
3. Press [Yes]. The unique switches will reset to factory defaults.
4. Press <Reset> to return the machine to standby.
3.5.3 List
000
• Congestion tone detection
001
• Enable the first tone key
• Enable the second tone key
• Enable the dial prefix key
003
• Display only direct input number on redial list
• The period before detecting busytone after dialing
010
• Including TTI inside the document
• The number of times PPR is detected during ECM transmission
013
• Encoding method for transmission
015
•
Returns from V28 to V8
• V.8 handshake in real time Tx
017
• JBIG transmission
018
• Disconnect the line when the transmission speed falls down under
7200 bps
• Disconnect the line when the transmission speed falls down under
4800 bps
• Transmission when disable to detect first NSF in real time transmis-
sion
019
• Number of redial times for archive transmission
020
• Transmit CED signal
• Printout the pages completed to receive during receiving into memory
021
• TCF check time (in 100 ms units)
022
• Document storage method
• MMR reception
• JBIG reception
023
• Encoding method for reception
029
• Displays the message “No Network Connection.”
030
• 3429 baud symbol rate when communicating at V.34
• 3200 baud symbol rate when communicating at V.34
• 3000 baud symbol rate when communicating at V.34
• 2800 baud symbol rate when communicating at V.34
• 2400 baud symbol rate when communicating at V.34
032
• ANSam output time
035
• Reception level at CED 2100 Hz
037
• The timing between V.34 handshake signals
050
• Smooth printing for printing normal document
051
• Give priority to “fit to paper”
052
• Printing margin adjustment
To Next Page
Loading...
Need help?
General
