Muratec MFX-3595 - Sensor Sg2 A 141

5-43
SENSOR SG2A 141
1. Remove two screws [1].
2. Disconnect the connector of the SENSOR SG2A 141 [2].
3. Remove the Guide lower exit 2 bins [4] while releasing three hooks [3].
4. Remove the Spring C feeler [5], then remove the Feeler sensor 2 bins [6].
5. Remove the SENSOR SG2A 141 [2].
* There are hooks on the short side (1 place) and the long side (2 places) on the sensor.
After releasing the hook on the short side, slide the sensor to the short side and remove it.
>

@
>

@
>

@
>

@
>

@
>

@
>

@
>

@