4-8
Phase Error code
Detail
Error code
Description Journal Redial Message
Note
Tx Phase B T.2.2 110D DIS or DTC that FIF is 00 00 00
has been received. DTS requires
hang up. German models only.
Yes No Confirm the remote fax. Normally, this error does
not occur.
110E The receiver has no box with
matching sub-address
Yes No F-Code Tx Error. No F-Code information in the
remote machine.
1115 Cannot fast remote diagnose Yes No No High-speed RDS. Cannot send a data. This error occurs at manual
reception.
1116 Trouble report was sent, but the
receiver was not a diagnose host
Cannot send a trouble report. Remote machine is
not RDS host.
T.2.3 1023 FTT returned at 2400 bps Cannot receive with minimum speed.
Tx Phase C T.3.1 1031 Document feeding error
Document length was over 1m
Lamp error
Scanner cover open error
Yes No Scanning error. Please send again.
Tx Phase D T.4.1 1041 Cannot receive MCF/RTN/RTP/
PIP/PIN
Yes Only at
memory
Tx
Confirm the remote fax.
T.4.2 1042 RTN was received No The remote machine could not receive document.
T.5.1 1051 No response to RR No Confirm the remote fax.
T.5.2 1052 No response to CTC No
T.5.3 1053 EOR output Cannot receive with minimum speed.
Tx V34 start
up
T.8.1 1081 V8 process did not finished
normally
Yes No Cannot send a fax in SuperG3 mode.
1800 Primary channel instruction did not
match at V8 mode
1801 Primary channel instruction did not
match at V8 mode (TX FAX)
1802 Primary channel instruction did not
match at V8 mode (RX FAX)
1803 Cannot adjust modulation
T.8.10 108A Cannot finish line probing normally No Yes
T.8.11 108B Cannot finish equalizer training
normally
Transmission
canceled
T.1.4 1014 Operator canceled the transmission Yes No Fax job was cancelled by user.
To Next Page
Loading...
