Specifications
page 30 of 66
Sydney MLK TypeS-Mid Sydney MLK TypeS-High
># of characters 40 characters 40 characters
0-14 times / Initial: 2 times(US)
0-14 times / Initial: 2 times(EUR)
0-14 times / Initial: 2 times(US)
>Redial interval 0-5 min. / Initial: 1 min.(US/EUR) 0-5 min. / Initial: 1 min.
># of characters 40 characters 40 characters
Redial again after the redial over no no
Communication time display on
Ground function(DEU) no no
Flash function(GBR) no no
PIN access function yes yes
># of characters for PIN access
no
yes (8 characters)
yes (8 characters)
Panel Operation during TEL1/TEL2
off-hooked
yes:TEL2 Only(USA/EUR)
yes:TEL2 Only(USA/EUR)
Manual Tx/Rx during TEL2 off-
hooked
・
numbers easier to read (doesn't
>Slash+P (/P) : enters a pause yes yes
>Slash+T (/T) :
switches from pulse-dialing to
>Slash+N (/N) : enters a dial
prefix number
>Slash+D (/D) : detects a dial
no (possible to activate by unique
no (possible to activate by unique
>Slash+S (/S) : detects second
dial tone
no (possible to activate by unique
switch)
no (possible to activate by unique
switch)
>Slash+F (/F) : make a flash
signal
no (possible to activate by unique
switch)
no (possible to activate by unique
switch)
>Slash+X (/X) : Dial to PSTN
from PBX with the optional 2nd
phone line
Number Display (JPN) N/A N/A
># of locations of Line connect
report ?
>SpeedDial Programming from
Number Display
Caller ID
yes(US)
no(EUR)
yes
Hooking for Call Waiting (JPN) no no
>Dial-in Securemail N/A N/A
Dialing at power failure yes (by external telephone) yes (by external telephone)