NEC NEAX 2000 - Page 258

DISTINCTIVE RINGING
– 238 –
A2234-10
DESCRIPTION DATA
Specify the interval of ringing signal for an
internal/external call.
(1)
(2)
392
-Pattern 1
0 : 2 sec. ON-4 sec. OFF
1 : 0.4 sec. ON-0.2 sec. OFF
-0.4 sec. ON-2 sec. OFF
-Pattern 2
0 : 0.5 sec. ON-0.5 sec. OFF
-0.5 sec. ON-1.5 sec. OFF
(D
term
)
0.4 sec. ON-0.2 sec. OFF
-0.4 sec. ON-2 sec. OFF
(Single Line Tel)
1 : 0.2 sec. ON-0.2 sec. OFF
-0.2 sec. ON-0.2 sec. OFF
-0.2 sec. ON-2 sec. OFF
Specify the lamp color for an incoming ex-
ternal call.
NOTE 1: The lamp color for incoming in-
ternal calls is red (120 IPM flash-
ing).
NOTE 2: For indicating the termination of
a transferred external incoming
call, the flashing lamp color de-
pends on CM08>137.
•
(1)
(2)
Y=32
00-63: Trunk Route No.
0 : Green (120 IPM)
1 : Red (120 IPM)
Specify the interval of ringing signal to a
D
term
on an incoming call.
•
(1)
(2)
Y=33
00-63: Trunk Route No.
0 : 0.4 sec. ON-0.2 sec. OFF,
0.4 sec. ON-2 sec. OFF
1 : 0.4 sec. ON-0.2 sec. OFF,
0.4 sec. ON-2 sec. OFF
2 : 1 sec. ON-2 sec. OFF
3 : As per CM08>392
Specify D
term
tone ringer on an incoming
call.
•
(1)
(2)
Y=34
00-63: Trunk Route No.
0 : 1024 + 1285
× 16 (Hz)
1 : 480 + 606
× 8 (Hz)
2 : 600 + 700 (Hz)
3 : 480 + 606
× 16 (Hz)
CM08
CM35
INITIAL
A
B