NETGEAR 7300 Series - Page 304

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
A-16 IS CLI Mapping
202-10009-01_060204
Routing config router ospf interface interval
dead <slot/port> <1-2147483647>
Interface
Config
ip ospf dead-interval
<1-2147483647>
Interface
Config
no ip ospf dead-interval
Routing config router ospf interface interval
hello <slot/port> <1-65535>
Interface
Config
ip ospf hellointerval <1-65535>
Interface
Config
no ip ospf hellointerval
Routing config router ospf interface interval
retransmit <slot/port> <0-3600>
Interface
Config
ip ospf retransmit-interval <0-3600>
Interface
Config
no ip ospf retransmit-interval
Routing config router ospf interface
iftransitdelay <slot/port> <1-3600>
Interface
Config
ip ospf transmit-delay <1-3600>
Interface
Config
no ip ospf transmit-delay <1-3600>
Routing config router ospf interface mode
<slot/port> <enable | disable>
Interface
Config
ip ospf
Interface
Config
no ip ospf
Routing config router ospf interface priority
<slot/port> <0-255>
Interface
Config
ip ospf priority <0-255>
Interface
Config
no ip ospf priority
Routing config router ospf interface cost
<ipaddr> <slot/port> <1-65535>
Interface
Config
ip ospf cost <1-65535>
Interface
Config
no ip ospf cost
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax