NETGEAR 7300 Series - Page 305

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
IS CLI Mapping A-17
202-10009-01_060204
Routing config router ospf area range
create <areaid> <ipaddr>
<subnetmask> [summ] [enable/
disable]
Router
OSPF
Config
area <areaid> range <ipaddr>
<subnetmask> {summarylink |
nssaexternallink} [advertise |
not-advertise]
Routing config router ospf area range
delete <areaid> <ipaddr>
<subnetmask> [summ]
Router
OSPF
Config
no area <areaid> range <ipaddr>
<subnetmask> {summarylink |
nssaexternallink}
Routing config router ospf area stub metric
value <areaid> <1-16777215>
Router
OSPF
Config
area <areaid> default-cost
<1-16777215>
Routing config router ospf area stub
summarylsa <areaid> <enable/
disable>
Router
OSPF
Config
area <areaid> stub summarylsa
Router
OSPF
Config
no area <areaid> stub summarylsa
Routing config router ospf area stub create
<areaid>
Router
OSPF
Config
area <areaid> stub
Routing config router ospf area stub delete
<areaid>
Router
OSPF
Config
no area <areaid> stub
Routing config router rip adminmode
<enable | disable>
Router
RIP
Config
enable
Router
RIP
Config
no enable
Routing config router rip prefrence <0-255> Router
RIP
Config
distance rip <1-255>
Routing config router rip interface
authentication <slot/port> <none |
simple> [key]
Interface
Config
ip rip authentication {none | {simple
<key>} | {encrypt <key> <keyid>}}
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax