NETGEAR 7300 Series - Page 307

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
IS CLI Mapping A-19
202-10009-01_060204
Routing config router ospf virtif interval
dead <areaid> <neighbor>
<1-65535>
Routing config router ospf virtif interval hello
<areaid> <neighbor> <1-65535>
Routing config router ospf virtif interval
retransmit <areaid> <neighbor>
<0-3600>
Routing config router ospf virtif delete
<areaid> <neighbor>
Router
OSPF
Config
no area <areaid> virtual-link
<neighborid>
Routing config router ospf
exoverfolwinterval
<0-2147483647>
Router
OSPF
Config
exit-overflow-interval
<0-2147483647>
Router
OSPF
Config
no exit-overflow-interval
Routing config router ospf extlsdblimit
<-1-2147483647>
Router
OSPF
Config
external-lsdb-limit <-1-2147483647>
Router
OSPF
Config
no external-lsdb-limit
Routing config router id <routerid> Router
OSPF
Config
router-id <ipaddress>
Routing config router route create
<networkaddr> <subnetmask>
<nexthopip> [metric]
Global
Config
ip route <networkaddr>
<subnetmask> <nexthopip> [0-255]
Routing config router route delete
<networkaddr> <subnetmask>
<nexthopip>
Global
Config
no ip route <networkaddr>
<subnetmask> <nexthopip>
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax