NETGEAR 7300 Series - Page 308

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
A-20 IS CLI Mapping
202-10009-01_060204
Routing config router route staticpreference
<local/static> <0-255>
Global
Config
ip route distance <1-255>
Routing config config router route default
create <nexthopip>
Global
Config
ip route default <nexthopip>
Routing config router route default delete Global
Config
no ip route default <nexthopip>
Routing config router vrrp adminmode
<enable/disable>
Global
Config
ip vrrp
Global
Config
no ip vrrp
Routing config router vrrp interface
adminmode <slot/port> <VrID>
<enable/disable>
Interface
Config
ip vrrp <VrID> mode
Interface
Config
no ip vrrp <VrID> mode
Routing config router vrrp interface priority
<slot/port> <VrID> <1-254>
Interface
Config
ip vrrp <VrID> priority <1-254>
Interface
Config
no ip vrrp <VrID> priority
Routing config router vrrp interface
ipaddress <slot/port> <vrID>
<ipaddr>
Interface
Config
ip vrrp <VrID> ip <ipaddress>
<ipaddr>
Routing config router vrrp interface
preemptmode <slot/port> <vrID>
<enable/disable>
Interface
Config
ip vrrp <VrID> preempt
Interface
Config
no ip vrrp <VrID> preempt
Routing config router vrrp interface
advinterval <slot/port> <vrID>
<seconds>
Interface
Config
ip vrrp <VrID> timers advertise
<1-255>
Interface
Config
no ip vrrp <VrID> timers advertise
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax