NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
IS CLI Mapping A-23
202-10009-01_060204
Routing config router rip splithorizon <none/
simple/poison>
Router
RIP
Config
split-horizon {none | simple | poison}
Router
RIP
Config
no split-horizon
Routing config router rip hostroutesaccept
<enable/disable>
Router
RIP
Config
hostroutesaccept
Router
RIP
Config
no hostroutesaccept
Switching show serviceport Privileged
EXEC
show serviceport
Switching show snmpcommunity Privileged
EXEC
show snmpcommunity
Switching show snmptrap Privileged
EXEC
show snmptrap
Switching show trapflags Privileged
EXEC
show trapflags
Switching show telnet Privileged
EXEC and
User
EXEC
show remotecon
Switching show forwardingdb agetime [fdbid |
all]
Privileged
EXEC
show forwardingdb agetime {<fdbid> |
all}
Switching config network parms <ipaddr>
<netmask> [gateway]
Privileged
EXEC
network parms <ipaddr> <netmask>
[<gateway>]
Switching config network protocol <none |
bootp | dhcp>
Privileged
EXEC
network protocol {none | bootp |
dhcp}
Switching config network webmode <enable |
disable>
Privileged
EXEC
ip http server
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax

NETGEAR 7300 Series Specifications

General

Model	NETGEAR 7300 Series
Form Factor	Rack-mountable
VLAN Support	Yes
Jumbo Frame Support	9KB
Management	Web-based, CLI
Layer	Layer 2/3