NETGEAR 7300 Series - Page 323

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
IS CLI Mapping A-35
202-10009-01_060204
Switching show mfdb table [macaddr/all] Privileged
EXEC
show mac-address-table multicast
[{<macaddr> | all}]
Switching show mfdb gmrp Privileged
EXEC
show mac-address-table gmrp
Switching show mfdb igmpsnooping Privileged
EXEC
show mac-address-table
igmpsnooping
Switching show mfdb statisticfiltering Privileged
EXEC
show mac-address-table
staticfiltering
Switching show mfdb stats Privileged
EXEC
show mac-address-table stats
Switching show mirroring Privileged
EXEC
show monitor
Switching config switchconfig broadcast
<enable/disable>
Global
Config
storm-control broadcast
Global
Config
no storm-control broadcast
Switching config switchconfig flowcontrol
<enable/disable>
Global
Config
storm-control flowcontrol
Global
Config
no storm-control flowcontrol
Switching config port adminmode <slot/port |
all> <enable | disable>
Interface
Config
shutdown
Interface
Config
no shutdown
Global
Config
shutdown all
Global
Config
no shutdown all
Switching config port linktrap <slot/port | all>
<enable | disable>
Interface
Config
snmp trap link- status
Table 13-2. IS CLI Mapping (continued)
Package 7300 Series L3 Switch Command
CLI Command
Mode Syntax