Firewall Protection
146
ProSecure Unified Threat Management (UTM) Appliance
Figure 80.
3. Enter the settings as explained in the following table.
Table 29. Add VLAN-VLAN Service screen settings
Setting Description
Service The service or application to be covered by this rule. If the service or application
does not display in the list, you need to define it using the Services screen (see
Add Customized Services on page 154).
Action The action for VLAN connections covered by this rule:
• BLOCK always
• ALLOW always
Source VLAN User The settings that determine which VLAN users who send traffic are affected by
this rule. The options are:
• Any. All PCs and devices that are part of the VLAN.
• Single address. Enter the required address in the Start field to apply the rule
to a single PC in the VLAN.
• Address range. Enter the required addresses in the Start and End fields to
apply the rule to a range of computers in the VLAN.
Destination VLAN User The settings that determine which VLAN users who receive traffic are affected by
this rule. The options are:
• Any. All PCs and devices that are part of the VLAN.
• Single address. Enter the required address in the Start field to apply the rule
to a single PC in the VLAN.
• Address range. Enter the required addresses in the Start and End fields to
apply the rule to a range of computers in the VLAN.
To Next Page
Loading...
Need help?
General