Using the Setup Wizard to Provision the UTM in Your Network
43
ProSecure Unified Threat Management (UTM) Appliance
Any of the following table buttons might display on screen:
• Select All. Select all entries in the table.
• Delete. Delete the selected entry or entries from the table.
• Enable. Enable the selected entry or entries in the table.
• Disable. Disable the selected entry or entries in the table.
• Add. Add an entry to the table.
• Edit. Edit the selected entry.
• Up. Move the selected entry up in the table.
• Down. Move the selected entry down in the table.
• Apply. Apply the selected entry.
Almost all screens and sections of screens have an accompanying help screen. To open the
help screen, click the (question mark) icon.
Use the Setup Wizard to Perform the Initial Configuration
The Setup Wizard facilitates the initial configuration of the UTM by taking you through 10
screens, the last of which allows you to save the configuration. If you prefer to perform the
initial WAN setup manually, see Chapter 3, Manually Configuring Internet and WAN Settings.
 To start the Setup Wizard:
1. Select Wizards from the main navigation menu. The Welcome to the Netgear
Configuration Wizard screen displays:
Figure 24.
2. Select the Setup Wizard radio button.
3. Click Next. The first Setup Wizard screen displays.
The following sections explain the 9 configuration screens of the Setup Wizard. On the 10th
screen, you can save your configuration.
The tables in the following sections explain the buttons and fields of the Setup Wizard
screens. Additional information about the settings in the Setup Wizard screens is provided in
other chapters that explain manual configuration; each of the following sections provides a
specific link to a section in another chapter.
To Next Page
Loading...
Need help?
General