NETGEAR UTM5 User Manual

Network and System Management
418
ProSecure Unified Threat Management (UTM) Appliance
3. Click Apply to save your settings.
Manage the Configuration File
The configuration settings of the UTM are stored in a configuration file on the UTM. This file
can be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory
default settings.
Once the UTM is installed and works correctly, make a backup of the configuration file to a
computer. If necessary, you can later restore the UTM settings from this file.
The Backup & Restore Settings screen lets you:
• Back up and save a copy of the current settings
• Restore saved settings from the backed-up file
• Revert to the factory default settings
Table 103. SNMP screen settings
Setting Description
Settings
Do You Want to
Enable SNMP?
Select one of the following radio buttons:
• Yes. Enable SNMP.
• No. Disable SNMP. This is the default setting.
Read Community The community string to allow an SNMP manager access to the
MIB objects of the UTM for the purpose of reading only. The default
setting is public.
Set Community The community string to allow an SNMP manager access to the
MIB objects of the UTM for the purpose of reading and writing. The
default setting is private.
Contact The SNMP system contact information that is available to the
SNMP manager. This setting is optional.
Location The physical location of the UTM. This setting is optional.
Enable Access
From WAN
Select the Enable Access From WAN check box to allow SNMP management over a
WAN connection. This check box is cleared by default, allowing SNMP management
only over a LAN connection.
Trusted SNMP Hosts
Enter the IP addresses of the computers and devices to which you want to grant read-only (GET) or write
(SET) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP host access,
leave the field blank, which is the default setting.
SNMP Traps
Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM’s SNMP
traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no
SNMP management station can receive the UTM’s SNMP traps.

NETGEAR UTM5 Specifications

General

Brand	NETGEAR
Model	UTM5
Category	Firewall
Language	English