System Logs and Error Messages
598
ProSecure Unified Threat Management (UTM) Appliance
System Log Messages
This section describes log messages that belong to one of the following categories:
• Logs that are generated by traffic that is meant for the UTM.
• Logs that are generated by traffic that is routed or forwarded through the UTM.
• Logs that are generated by system daemons: the NTP daemon, the WAN daemon, and
others daemons.
System Startup
This section describes log messages generated during system startup.
Reboot
This section describes log messages generated during a system reboot.
Service Logs
This section describes log messages generated during firmware updates and other
service-related events.
Table 155. System logs: system startup
Message Jan 1 15:22:28 [UTM] [ledTog] [SYSTEM START-UP] System Started
Explanation Logs that are generated when the system is started.
Recommended Action None.
Table 156. System logs: reboot
Message Nov 25 19:42:57 [UTM] [reboot] Rebooting in 3 seconds
Explanation Logs that are generated when the system is rebooted from the web management
interface.
Recommended Action None.
Table 157. System logs: service
Message 2008-12-31 23:59:48 error Firmware update failed! Either the subscription is not yet
registered, or has expired.
Explanation Logs that are generated when a firmware update fails or succeeds. The message
shows the date and time, and the event.
Note: The service log includes miscellaneous service messages.
Recommended Action None.
To Next Page
Loading...
Need help?
General