Using the Setup Wizard to Provision the UTM in Your Network
64
ProSecure Unified Threat Management (UTM) Appliance
What to Do Next
You have completed setting up the UTM to the network. The UTM is now ready to scan the
protocols and services that you specified and perform automatic updates based on the
update source and frequency that you specified.
If you need to change the settings, or to view reports or logs, log in to the UTM web
management interface, using the default IP address or the IP address that you assigned to
the UTM in Setup Wizard Step 1 of 10: LAN Settings on page 44.
The UTM is ready for use. However, the following sections describe important tasks that you
might want to address before you deploy the UTM in your network:
• Configure the WAN Mode (required for the multiple WAN port models).
• Configure Authentication Domains, Groups, and Users
• Manage Digital Certificates for VPN Connections
• Use the IPSec VPN Wizard for Client and Gateway Configurations
• Use the SSL VPN Wizard for Client Configurations
To Next Page
Loading...
Need help?
General